Submissions

Online Submissions

Registration and login are required to submit items online and to check the status of current submissions.

Already have a Username/Password for Journal of Mechanical Engineering and Vocational Education (JoMEVE)?

Go to Login Start New Submission

Need a Username/Password?

Go to Registration
 

Author Guidelines

  1. The article must be scientific, either based on empirical research or conceptual ideas. The content of the article has not published yet in any Journal, and should not be submitted simultaneously to another Journal. The article should not be part of fully one chapter of the theses or dissertation.
  2. The article must be in the range between 15-20 pages, not including title, abstract, keywords, and bibliography
  3. Article consisting of the various parts: i.e. title, the author’s name(s) and affiliation(s), abstract (150-200 words), Keywords (maximum 5 words), introduction, description and analysis, conclusion, and bibliography.
  4. Citation’s style used is the American Psychological Association (APA) 6th Edition.
  • The title should not be more than 20 words.
  • Author s name(s) should be written in the full name without academic title (degree), and completed with institutional affiliation(s) as well as corresponding address (e-mail address).
  • Abstract consisting of the discourses of the discipline area; the aims of the article; methodology (if any); research finding; and contribution to the discipline of areas study. The abstract should be written in English.
  • Introduction consisting of the literature review (would be better if the research finding is not latest than ten years) and novelty of the article; scope and limitation of the problem discussed; and the main argumentation of the article.
  • Discussion or description and analysis consisting of the reasoning process of the article s main argumentation.
  • The conclusion should be consisting of answering research problem, based on the theoretical significance/conceptual construction
  • All of the bibliography used should be written properly

 

Submission Preparation Checklist

As part of the submission process, authors are required to check off their submission's compliance with all of the following items, and submissions may be returned to authors that do not adhere to these guidelines.

  1. The submission has not been previously published, nor is it before another journal for consideration (or an explanation has been provided in Comments to the Editor).
  2. The submission file is in OpenOffice, Microsoft Word, RTF, or WordPerfect document file format.
  3. Where available, URLs for the references have been provided.
  4. The text is single-spaced; uses a 12-point font; employs italics, rather than underlining (except with URL addresses); and all illustrations, figures, and tables are placed within the text at the appropriate points, rather than at the end.
  5. The text adheres to the stylistic and bibliographic requirements outlined in the Author Guidelines, which is found in About the Journal.
  6. If submitting to a peer-reviewed section of the journal, the instructions in Ensuring a Blind Review have been followed.
 

Copyright Notice

With the receipt of the article by the Journal of Mechanical Engineering and Vocational Education (JoMEVE) Editorial Board and the decision to be published, then the copyright regarding the article will be diverted to JoMEVE.

Mechanical Engineering Education, Faculty of Education, Universitas Sebelas Maret Surakarta as the publisher of JoMEVE hold the copyright regarding all the published articles in this journal. 

Mechanical Engineering Education, Faculty of Education, Universitas Sebelas Maret Surakarta has the right to multiply and distribute the article and every author is not allowed to publish the same article that was published in this journal. 

Journal of Mechanical Engineering and Vocational Education (JoMEVE) is licensed under a Creative Commons Attribution-ShareAlike 4.0 International License.

Creative Commons License
This work is licensed under a Creative Commons Attribution-ShareAlike 4.0 International License.

 

Privacy Statement

The names and email addresses entered in this journal site will be used exclusively for the stated purposes of this journal and will not be made available for any other purpose or to any other party.

 

Author Fees

This journal charges the following author fees.

Article Submission: 0.00 (IDR)
Authors are free charge to do the article submission

Article Publication: 500000.00 (IDR)
Authors are free charge to article publication

If you do not have funds to pay such fees, you will have an opportunity to waive each fee. We do not want fees to prevent the publication of worthy work.