Author Guidelines
All manuscripts must be submitted to Journal of Global Environmental Dynamics (JGED) to Editorial Office through Online Submission where author must register as Author. If authors are experiencing problems on the online submission, they can contact Editorial Office at email: hawalihashfi@staff.uns.ac.id
The following documents must be submitted together with the manuscript (as supplementary files):
- A Manuscript with camera ready format under following Journal Template
- A cover letter, outlines the basic findings of the paper and their significance.
- List of Potential Reviewers for your manuscript. Please send the detail by their email and affiliation address.
Reviewing manuscripts
Every submitted paper is independently reviewed by at least two peer-reviewers. Decision for publication, amendment, or rejection is based upon their reports/recommendation. If two or more reviewers consider a manuscript unsuitable for publication in this journal, a statement explaining the basis for the decision will be sent to the author immediately.
Revision of manuscripts
Manuscripts sent back to the authors for revision should be returned to the editor without delay. Revised manuscripts can be sent to editorial office through the Online Submission Interface. The revised manuscripts returned later than three months will be considered as new submissions.
STANDARD PAPERS. Original articles (at least 6000 words) inclusive of all parts of the paper. Typescripts should be arranged as follows, with each section starting on a separate page.
Title Page:
- A concise and informative title.
- A list of author names, affiliation(s), and e-mail addresses.
- The name, complete mailing address (including e-mail address, telephone and fax numbers) of the corresponding author.
Abstract: A concise and factual abstract (150-250 words) is required. The abstract should state briefly the purpose of the research, the principal results and major conclusions. An abstract is often presented separately from the article, so it must be able to stand alone. For this reason, References should be avoided. Also, non-standard or uncommon abbreviations should be avoided, but if essential they must be defined at their first mention in the abstract itself.
Keywords: A list in alphabetical order not exceeding ten words or short phrases, excluding words used in the title and chosen carefully to reflect the precise content of the paper.
Introduction: State the reason for the work, the context, background, aims and the hypotheses being tested. End the Introduction with a brief statement of what has been achieved.
Materials and methods: Include sufficient details for the work to be repeated. Where specific equipment and materials are named, the manufacturer’s details (name, city and country) should be given so that readers can trace specifications by contacting the manufacturer. Where commercially available software has been used, details of the supplier should be given in brackets or the reference given in full in the reference list.
Results and Discussion: State the results of experimental or modelling work, drawing attention to important details in tables and figures and discuss them intensively by citing other references.
Conclusion: Give the main findings and conclude the result and discussion.
Acknowledgements: Be brief. If authors refer to themselves as recipients of assistance or funding. Do not acknowledge Editors by name.
References: (see Manuscript Specifications below).
Tables: Each table should be inserted in body-text and numbered as well as accompanied by a legend at the top. These should be referred to in the text as Table 1, etc. Avoid duplication between figures and tables.
Figures: Figures and their legends should be inserted in body text manuscript. Figures should be referred to in the text as Fig. 1, Figs 1 & 2, etc. Photographic material should also be referred to as Figures. The figures must be in high resolution and no blur.
CITATIONS AND REFERENCES. Citation and reference follow the Harvard Reference Format 1 style. Citation to work by four or more authors should be abbreviated with the use of et al. e.g. (Dwi Nugraha et al., 2018). Citation to work by one, two or three authors should always give the author names in full e.g. (Matin and Hadiyanto, 2018). Citations should be listed in chronological order in the text and be separated by a semi-colon, e.g. (Lu et al., 2009; Budiyono et al., 2018; Nugraha et al., 2018). The references in the Reference list should be in alphabetical order with the journal name unabbreviated. The format for papers, theses, entire books and chapters in books is as follows:
Journal:
Matin, H. H. A. and Hadiyanto, H. (2018) ‘Optimization of biogas production from rice husk waste by solid state anaerobic digestion (SSAD) using response surface methodology’, Journal of Environmental Science and Technology, 11(3), pp. 147–156. doi: 10.3923/jest.2018.147.156.
Books:
Begon, M., Harper, J.L. & Townsend, C.R. (1996) Ecology: Individuals, Populations and Communities, 3rd edn. Blackwell Science, Oxford.
Thesis/Disertation:
Tuyttens, F.A.M. (1999) The consequences of social perturbation caused by badger removal for the control of bovine tuberculosis in cattle: a study of behaviour, population dynamics and epidemiology. PhD thesis, University of Oxford.
References should be cited as 'in press' only if the paper has been accepted for publication. Work not yet submitted for publication or under review should be cited as 'unpublished data', with the author's initials and surname given; such work should not be included in the Reference section.
REVIEWS ARTICLE. Reviews should at least 10000 words inclusive of all parts of the paper. The layout should follow the same format and specifications as for Standard Papers except that the organization of the main text need not follow the division into Introduction, Materials and methods, Results and Discussion.
SHORT COMMUNICATION ARTICLES. Communication articles should be short contributions up to 4000 words inclusive of all parts of the paper. Format and specifications are as for Standard Papers except that any Summary section should be short (no more than 150 words) and the layout of the main text can be flexible.
