Synthesis of Syngas into Dimethyl Ether Using Cu-Zn-Al/-Alumina Bifunctional Catalyst as an Environmentally Friendly Fuel for Substituting Liquified Petroleum Gas

Suratno Lourentius

Abstract

Abstract. In order to meet the need for Liquified Petroleum Gas in Indonesia, which is currently around seventy percent of which is still imported, it is necessary to find a replacement. One of the efforts to replace the Liquified Petroleum Gas is by utilizing dimethyl ether which can be produced from coal as raw material. Coal can be catalytically converted to syngas and then syngas can be catalytically converted to dimethyl ether via a direct two-step or one-step route. This paper will discuss the one-step synthesis of dimethyl ether from syngas using Cu-Zn-Al/g-Alumina as a bifunctional catalyst. The syngas used consists of carbon monoxide and hydrogen with a mole ratio of 1:2. The conversion reaction was carried out in a fixed-bed reactor at the pressure of 40 bar, the temperature of 240-300 0C, and the space velocity of 29.3-32.7 mL/g catalyst/minute. The highest conversion of CO that can be achieved is 90.08 % at a temperature of 300 oC and the space velocity of 29.3 mL/g catalyst/minute. The synthesis product was analyzed using GC. The dimethyl ether is an environmentally friendly fuel and non-toxic compound that does not destroy ozone, does not contain sulfur, and has a calorific value of about 30.5 MJ/kg which is lower than 50.56 MJ/kg

Full Text:

PDF

References

[1] Suharyati, S. H. Pambudi, J. L. Wibowo and N. I. Pratiwi, “Indonesia Energy Outlook 2019”, Jakarta, Indonesia: DEN Secretariat National, Energy Council, 2019

[2] Ministry of Energy and Mineral Resources, Republic of Indonesia, (2018) “Indonesia's Coal Reserves of 26 Billion Tons”, Available: https://www.esdm.go.id [Accessed: 21 Maret 2018]

[3] M. E. Harahap and E. W. Tjahjono, “Study of Synthetic Gas Manufacturing Process Technology from Coal and Prospects of Utilization in Downstream Industries”, M.P.I., vol. 10, no. 1, pp. 61-70, Apr, 2016

[4] W. Cheng and H. H. Kung, “Methanol Production and Use”, New York: Marcel Dekker Inc., 1994, pp. 1-132

[5] C. D. Holland and R. G. Antony., “Fundamental of Chemical Reation Enginering”, 2nd ed., New Jersey, Prentice Hall International Editions, 1989, pp. 348-394

[6] M. Xu., D. W. Goodwan, and A. Battacharyya, “Catalytic Dehydration of Methanol to Dimethyl Ether (DME) Over Pd/Cab-O-Sil Catalyst”, Applied Catalysis A: General, vol 149, pp. 303-309, 1997

[7] C. Moreno-Castilla, F. Carrasco-Marin, C. Pajero-Perez and M. V. Lopez Ramon, “Dedydration of Methanol to Dimethyl Ether Catalyzed by Oxidized Activated Carbon With Varying Surface Acidic Character”, Carbon, vol. 39, pp. 869-875, 2001

[8] A. C. Sofianos and M. S. Scurrell, “Conversion of Synthesis Gas to Dimethyl Ether Over Bifunctional Catalyst Systems”, Ind. Eng. Chem. Res., vol 30, pp. 2372-2378, 1991

[9] J. L. Li, X. G. Zhang and T. Inui, “Improvement in the Catalyst Activity for Direct Synthesis of Dimethyl Ether from Synthesis Gas Through Enhancing the Dispersion of CuO/ZnO/-Al2O3 in Hybrid Catalysts”, Applied Catalysis A: General, vol. 147, pp. 23-33, 1996

[10] Q. Ge, Y. Huang, F. Qui and S. Li, “Bifunctional Catalyst for Conversion of Synthesis Gas to Dimethyl Ether”, Applied Catalysis A: General, vol. 167, pp. 23-30, 1998

[11] T. Takeguchi, K. Yanagisawa, T. Inui and M. Inoue, “Effect of The Property of Acid Upon Syngas-to-Dimethyl Ether Conversion on Hybrid Catalyst of Cu-Zn-Ga and Solid Acids”, Applied Catalysts A: General, vol. 192, pp. 201-209, 2000

[12] K. Omata, Y. Watanabe, T. Umegaki, T. Ishguro, and G. Yamada, “Low Pressure DME Synthesis With Cu-Based Hybrid Catalysts Using Temperature Gradient Reactor”, Fuel, vol. 81, pp. 1605-1609, 2002

[13] K. Sun, W. Lu, F. Qui, S. Xu and X. Xu, “Direct Synthesis of DME Over Bifunctional Catalyst Surface Properties and Catalytics Performance”, Applied Catalysis A: General, vol. 252, pp. 243-249, 2003

[14] Y. Ohno, “New Clean Fuel Dimethyl Ether (DME) Synthesis Technology”, The Paper Presented on Seminar about DME held in ITS Surabaya, pp. 1-27, Apr, 2002

[15] B. E. Poling, J. M. Prausnitz and J. P. O’Connell, “The Properties of Gases and Liquids”, 5 th ed., New York, The McGraw-Hill Companies, Inc., 2001, pp. A-1 – A-60

[16] J. M. Smith, H. C. Van Ness, and M. M. Abbott, “Introduction to Chemical Engineering Thermodynamics”, 7th Ed., New York, The McGraw-Hill Companies, Inc, 2005, pp. 484-510

[17] T. Shikada, O. Yotaro, T. Ogawa, M. Mizoguchi, “Materal Method and Apparatus for Producing Dimethyl Ether”, US Patent 6147125, pp. 1-44, Nov., 2000

[18] S. Lourentius, “Kinetika Reaksi Katalitik Konversi Syngas Menjadi Dimethyl Ether”, Prosiding Seminar Nasional Teknik Kimia “Kejuangan” Universitas Pembangunan Nasional “Veteran”, Yogyakarta, 2008, pp. C10-1-C10-6

[19] G. R. Moradi, J. Ahmadpour, F. Yaripour, J. Wang, “Equilibrium calculations for direct synthesis of Dimethyl ether from syngas”, Can. J. Chem. Eng. 89:108–115, Feb, 2011

DOI: https://doi.org/10.20961/equilibrium.v5i2.58479

Refbacks

  • There are currently no refbacks.